Navigation Of The Htrm Controls - NAD M15 Owner's Manual

Av surround sound preamplifier
Hide thumbs Also See for M15:
Table of Contents

Advertisement

M15 02 23 2006.qxd
3/7/2006
Identification of controls
ABOUT THE HTRM
18
9:06 AM
Page 18
BACKLIGHT
The HTRM is equipped with a backlight to increase visibility of the HTRM in low light
conditions. The HTRM also includes a light sensor. By default, if you press any key on the
remote and it senses a low light condition, the back light will turn on. It will then turn off again
five seconds after no key has been pressed.
The behaviour and timeout for the backlight can be adjusted. (Refer to the "HTRM Features"
for further information.)
LOW BATTERY WARNING
If the HTRM senses the batteries are low, it will show "Low Batt" on the second line of the
LCD display whenever the remote is idle. When this occurs the batteries should be replaced
with new ones immediately.
DEVICE SELECTOR KEYS
Simply pressing a DEVICE SELECTOR key will change the active device on the HTRM. At this
time, no IR commands will be transmitted. The name of the selected device will be shown on
the first line of the LCD display.
Note: Any IR command can be associated with a DEVICE SELECTOR key during "Copy" and
"Learn" modes. Once the associated function is assigned to the DEVICE SELECTOR key
pressing and holding the DEVICE SELECTOR key for more than two seconds will send the
associated command in addition to the HTRM switching its active device.

NAVIGATION OF THE HTRM CONTROLS

MACRO KEYS
A macro can be associated with every key on the HTRM except for the MACRO button itself.
A total of 52 macros can be stored.
To execute a macro:
Press the MACRO key. The first line of the LCD display will show "MACRO".
Within five seconds, press the key the macro is associated with.
While the macro is executing a small "M" will be shown in the top right of the LCD
display. (refer to the Setup Menu section for information on how to setup macros)
FUNCTION KEYS
There are 44 dedicated function keys on the HTRM. When you press a function key, the name
of the function will be shown on the second line of the LCD display while the command is
being transmitted.
A/V PSET KEY
In the default configuration of the HTRM, the A/V PSET key acts as a shift function when the
AMP device is selected. Pressing the A/V PSET key once will cause "Preset" to be displayed
on the first line of the LCD display. If within five seconds you then press a digit 0 - 9, the
function for the corresponding A/V Preset will be transmitted.
Note: The HTRM is an universal-type remote control, some NAD receivers may not have
more than 5 AV presets.
SETUP MENU
Press and hold the SETUP and ENTER keys for five seconds to enter the Setup Menu. You
cannot enter the setup menu if the remote is currently displaying "Low Batt". This feature
prevents the setup from becoming corrupted under low battery conditions.
Please refer to Setup Navigation for the overall structure and basic operation of the Setup
Menu.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents