Bullet Cameras Installation - E-Vision BUMDV01FAHD Quick Manual

•STEP 4
A : fix the camera in place and screw the dome again, removing any protective film and placing a Silica Gel packet inside
(See chapter 4.4 on page 19).
If you need to have the cable go out through the side hole, loosen the grub screw on the side with the provided hex key and
proceed with item B
B : remove the base by rotating it clockwise. Place the cable in its special path, then set the base in place again by rotating
it anticlockwise and by tightening the grub screw again.
A

4.3 Bullet cameras installation

•STEP 1
Drill the holes for the dowels, insert the dowels into the holes, and screw the base to the dowels with the screws (both
dowels and screws provided).
Quick Guide - Telecamere AHD Full HD - 090010937
B
Close
16
Open