Table of Contents
Advertisement
Quick Start Guide
Installation Overview
Installing your sensor is a simple two-step process.
1
You have to register your sensor with your Gateway using a process called discovery. Your
sensor must be powered before you attempt discovery. Refer to your Gateway documentation for
instructions on how to discover your Temperature Sensor.
2
Mount the sensor.
Installing the Sensor
The Motorola Temperature Sensor is constructed of UV resistant ABS plastic allowing for indoor or
outdoor use. The spacing between the sensor and the contact should be between 1/10 inch and ½
inch (.25 cm to 1.27 cm).
If you paint your Motorola sensor, use a non-conductive latex paint. Remove the batteries from the sensor before
painting and allow adequate time for the paint to dry before reinserting batteries. Make sure you do not let paint
run into the openings of the sensors to prevent damage to the electrical circuitry.
Insert the Antenna
Locate the antenna and screw it into the top right corner of the sensor, just above the air
vents, until it tightly fits. Sharp objects should be stored out of reach of children to prevent
injury.
Insert the Batteries
1
On the bottom of the sensor, slide open the door and insert two AAA alkaline
batteries. The back of the door of the sensor indicates the polarity (+ and -) of the
batteries.
2
Close the door.
The sensor does not support rechargeable NiCad or NiMH batteries. However, the sensor does employ power
saving functionality.
Page 2
The Gateway must be installed before activating your sensor!
Temperature Sensor
Advertisement
Table of Contents
