Page of 2

Motorola HDT100 Quick Setup Manual

High definition tuner.
Hide thumbs
   

Advertising

Important Safety Instructions
Be sure to allow adequate ventilation and airflow around the HDT100 to prevent overheating.
V E N T I L A T E
2
inch space
2
inch
POWER
SIGNAL LOSS
MENU
ENTER
EXIT
-
Position the HDT100 with at least 2 inches of space above and on all sides.
-
Do not block the slots and openings in the HDT100.
-
Do not place anything on top of the HDT100.
-
Do not position the HDT100 in an enclosed space that would restrict airflow around the unit.
-
Do not position the HDT100 near any external heat source that could raise the temperature around the unit.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Graphical symbols and supplemental warning marking locations on bottom of terminal.
WARNING
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
TO PREVENT ELECTRICAL SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point, within an equilateral triangle, is intended to alert the user to the presence
of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
REPAIRS
If you find the unit in need of repair, call Motorola Support at
1-866-668-2271
or
1-866-MOT-BCS1
.
EXAMPLE OF ANTENNA GROUNDING
Electric service
equipment
Ground
Antenna lead
clamp
in wire
Antenna
discharge unit
(NEC Section 810-20)
Grounding
Grounding conductors
clamps
(NEC Section 810-21)
Power service grounding
electrode system
(NEC Article 250, Part H)
NEC=NATIONAL ELECTRICAL CODE
2
inch
POWER
Visit our website at:
www.motorola.com
504781-001
07/03
MGBI
POWER
SIGNAL LOSS
MENU
ENTER
EXIT
Motorola HDT100
High Definition Tuner
Quick Set-Up Guide
POWER

   Also See for Motorola HDT100

   Related Manuals for Motorola HDT100

   Summary of Contents for Motorola HDT100

  • Page 1

    Do not place anything on top of the HDT100. Do not position the HDT100 in an enclosed space that would restrict airflow around the unit. Do not position the HDT100 near any external heat source that could raise the temperature around the unit. CAUTION...

  • Page 2

    Once you complete your video connections, proceed to the instructions for the audio connections. AUTO SCAN Before you can start using the HDT100, you need to program it with the station numbers of the over-the-air digital TV stations available in your area. This can be done by simply running...

Comments to this Manuals

Symbols: 0
Latest comments: