Download Print this page

Motorola MOTONAV T805 User Manual: Belt Clip; Universal Phone Holder (uph)

Phone-based navigation system.
Hide thumbs

Advertisement

1. Adhesive: Locate the round adhesive pad. Peel off the backing on one of the adhesive pads
supplied. Attach the adhesive pad to the bottom of the dash mount bracket. Peel off the backing
on the other side of the adhesive pad and firmly stick the dash mount bracket to the dash. For
the strongest signals, choose a spot where the GPS receiver can have a clear view of the sky.
2. Velcro: Locate the supplied round Velcro pad. Peel off the protective backing on one side and
stick the pad to the bottom of the dash mount bracket. Remove the remaining protective backing
and stick the Velcro to the desired spot on the dash. To remove the bracket, separate the Velcro
pad.
3. Friction pad: Locate the friction pad, remove the backing, and stick it to the bottom of the dash
mount. The friction pad allows the GPS receiver to sit on the dash without it sliding around.

Belt Clip

Note: The belt clip for MOTONAV is only available in Europe.
The GPS receiver can easily be snapped into the belt clip for use outside of a vehicle. Make sure the belt
clip is firmly attached to a belt or strap to avoid dropping it.

Universal Phone Holder (UPH)

The universal phone holder (UPH) is used to hold the phone such that the display is visible to the driver.
It has several ways it can be attached:
1. Gooseneck Mount: The gooseneck mount can be attached to a smooth surface by its suction
cup. Press the suction cup firmly to a smooth surface and push the thumb lever down. Flip the
thumb lever up and pull the tab to release. If needed, the cup can be slightly moistened for better
adhesion. While mostly intended to be mounted to the windshield, a suction cup base is also
provided for mounting the gooseneck to non-smooth surfaces. Locate the suction cup base and
remove the protective covering from the adhesive on the bottom. Press the base firmly down
onto the appropriate location on the dash. The suction cup can then be pressed into the suction
cup base and the lever flipped. Attach the UPH to the other end of the gooseneck by sliding it
over the hooks on the end of the gooseneck.
Suction Cup
Base
2. Adhesive mount: Locate the rectangular adhesive patch. Remove the yellow
backing and press it firmly to the back of the UPH. Remove the green backing and
press the UPH to the desired spot on the dash.
3. Velcro mount:
protective backing from one side of the patch and press the patch to the bottom of
the UPH. Remove the remaining protective backing and press the UPH to the desired
spot. The UPH can then be removed by separating the Velcro patch.
To insert a phone into the UPH: Push the side release button to expand the side grippers to their
maximum reach. Insert your phone, and gently squeeze the side grippers until the soft rubber edges grip
the phone. Check all of the grippers to see if they are interfering with any phone buttons. The bottom
grippers are movable to fit around any phone feature that gets in the way. If needed, the bottom grippers
Locate the rectangular Velcro patch (supplied).
UPH
Release Tab
Remove the
14

Advertisement

   Also See for Motorola MOTONAV T805

   Related Manuals for Motorola MOTONAV T805

This manual also for:

V3x - razr cell phone

Comments to this Manuals

Symbols: 0
Latest comments: