Advertisement
6. SOLVENT CHANGE & MAINTENANCE
F WARNING! It is the operators responsibility to ensure that there is no uncontrolled discharge of any fluids used with this unit and that
appropriate arrangements have been made for correct disposal of waste fluids in accordance with government and local authority regulations.
F
WARNING! Disconnect the washer from the air supply before changing accessories, servicing or performing any maintenance.
p
F
WARNING! Wear approved safety eye protection, mask and gloves. If fluid gets on skin or in eyes wash thoroughly with water
p
and take any other action as required by the solvent instructions.
6.1
TO CHANGE SOLVENT
The amount of guns a 25 litre drum of solvent can clean will depend upon the amount of residue paint which is left in spray
equipment. We recommend however that the solvent is changed on a regular basis to provide optimum machine performance.
6.1.1. Close the drain tap, and remove drain hose and filter from container. Store the used solvent in accordance with regulations.
6.1.2. Clean the filter before reuse.
5.1.3. Insert the filter and hose into a new solvent drum as in section 4.
Wipe up any spillage immediately.
6.2.
MAINTENANCE.
6.2.1. Clean the inside of the tank just before changing the solvent. To do so, close the drain tap (fig 4 & 2.B), start the machine and allow
a quantity of fluid to enter the tank. Turn machine off, lift lid and use the fluid to clean out the inside of the tank, removing any residue
waste. Open the drain valve to empty the tank.
6.2.2. Keep pick-up filter clean by rinsing in solvent and blowing out with an air line.
6.2.3. Change the green base filter (Model no SM2399/15) every three months, or more frequent if heavy use.
6.2.4. Regularly check to ensure there are no obstructions to the extraction flue.
6.2.5. Periodically check for correct operation of lid ‘cut-off’ device and air extraction.
6.2.6. Regularly inspect the air hoses and fittings to ensure their integrity.
6.2.7. Keep the outside of the unit clean.
SPRAY GUN CLEANING TANK
MODEL SM2399
93/68/EEC CE Marking Directive
89/336/EEC Directive (S.I. 1992/2372) & Amendments
98/37/EEC Machinery Directive (S.I 1992/3073)
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
01284 757500
p
p
Declaration of Conformity
is in conformity with the following EEC standards and directives
Signed by Mark Sweetman
The construction file for this product is held by the Manufacturer and may be inspected on request by contacting Jack
Sealey Ltd
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 703534
We, the sole importer into the UK, declare that the product listed here
1st August 1999
E-mail: sales@sealey.co.uk
Advertisement
