A/V Receiver; A/V Receiver With Hdmi Output - Mitsubishi Electric WD-60737 Owner's Manual

20
2. TV Connections

A/V Receiver

Most setups require either a digital audio cable or
analog stereo audio cables. To send audio from TV
channels received on the ANT input or devices con-
nected directly to the TV, you must use one of the
connections shown below. Usually, only one of these
connections is required.
The TV makes all audio available in digital and analog
formats:
• Analog audio coming into the TV is available as
output in digital stereo format on the DIGITAL
AUDIO OUTPUT jack.
• Digital incoming audio is available as analog output
on the AVR AUDIO OUTPUT L and R jacks.
L
AVR
AUDIO
OUTPUT
R
L L
AVR
AUDIO
HDMI OUTPUT
R R
1 2 3
DIGITAL DIGITAL
AUDIO AUDIO
OUTPUT OUTPUT
Stereo analog
cables
(for an analog
A/V receiver)
A/V receiver back panel
Note:
• On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from
the TV as a digital signal. To hear these copy-
protected signals through the A/V receiver, use
the connection for an analog A/V receiver.
• Check the A/V receiver's Owner's Guide for
information concerning use of the digital input
and switching between digital sound and
analog stereo sound from the TV.
TV main panel
RS-232C
DVI/PC INPUT
ANT
AUDIO L
R
3D
Y/ VIDEO Pb Pr
GLASSES
EMITTER
Pr
Y/ VIDEO Pb
R AUDIO L (480i / 480p / 720p / 1080i) IR-
NetCommand R
Output
DIGITAL
AUDIO
OUTPUT
Digital coaxial cable
(for a digital A/V
receiver)
OPTICAL
INPUT
COAXIAL COAXIAL
INPUT INPUT

A/V Receiver with HDMI Output

Required: One HDMI-to-HDMI cable
This option allows you to view content from devices
connected to an A/V receiver. The A/V receiver can
send audio and video to the TV over a single HDMI
cable. You can use an HDMI connection as described
here in addition to an audio connection from the TV's
audio output. The optional audio connection allows you
to hear, through the A/V receiver, devices connected to
the TV only, e.g., an antenna on the ANT input.
You may be able to use the TV's remote control (in
TV mode) to operate connected CEC-enabled HDMI
devices. Experiment with your equipment to determine
which functions are available to the TV's remote control.
See Appendix C, page 67.
837 Series: This setup allows you to use NetCom-
mand-controlled audio and video switching over the
HDMI cable. See "Case 3: Automatic Audio and Video
Switching via HDMI" on page 55.
To use NetCommand to supplement HDMI control of a
CEC-enabled A/V receiver, note the recommendations
under "More About Using an HDMI Connection," page 55.
DVI/PC
R
L L
AVR
AUDIO
HDMI HDMI OUTPUT
R R
1 1 2 2 3 3
DIGITAL DIGITAL R
AUDIO AUDIO
OUTPUT OUTPUT
Optional analog or
A/V receiver
with HDMI
output
HDMI OUT
High-definition
DVD player
Cable box
INPUT
ANT
AUDIO L
TV main panel
3D
Y/ VIDEO Pb Pr
GLASSES
EMITTER
L
AVR
AUDIO
Pr
Y/ VIDEO Pb
OUTPUT
AUDIO L (480i / 480p / 720p / 1080i) IR-
R NetCommand R
Output
DIGITAL
AUDIO
OUTPUT
digital audio
connection
L R
DIGITAL
AUDIO
VCR
DVD player