Mitsubishi Electric XD300U User Manual page 17

CINEMA MODE .. When ON is selected, the film mode will be automatically activated when a film source signal
is inputted. When OFF is selected, the film mode will not be activated.
VIDEO SIGNAL ... When AUTO is selected, the appropriate video format is automatically selected depending
on the input signal. If the image isn't displayed correctly, select the desired video format
manually.
SCART INPUT ... Select ON when connecting with a device equipped with the SCART terminal that can
output RGB signal. SCART terminal is used mainly in Europe. Select OFF normally.
ANAMORPHIC... Select ON when playing DVD discs containing data of widescreen images.
LANGUAGE ....... Use to select the language used in the menus. (
/ Italiano /
RESET ALL ........ Use to reset the MENU settings (except LANGUAGE).
• When SCART is set to ON, nothing is output to the external monitor.
• When SCART is set to ON, normal computer signals are not projected.
• Use optional SCART-Mini D-SUB 15P cable, when connecting with AV device equipped with the SCART
terminal.
• Some AV devices equipped with the SCART terminal may not be compatible with the projector.
• When VIDEO SIGNAL is set to AUTO, the image may not be projected with correct colors. Change the setting of
VIDEO SIGNAL depending on the input signal in such cases.
4 SIGNAL
HORIZ. POSITION .... Use to adjust the horizontal position of the image.
VERT. POSITION ..... Use to adjust the vertical position of the image.
TRACKING ......... Use to avoid image noise such as wide stripes.
FINE SYNC. ....... Use to synchronize the projector with PC input signals so
that the image is not blurred.
COMPUTER INPUT ...... This will be set automatically to match the input signal
to component video (YC
overridden as required.
HOLD .................. Adjusts the image when flagging occurs near the top of
the screen.
5 SIGNAL - USER (Normally, there is no need for adjustments.)
CLAMP POSITION/
CLAMP WIDTH ......... If you use something similar, the brighter colors of the
projected image may become blurred. In this case,
adjust CLAMP POSITION or CLAMP WIDTH.
VERT. SYNC ...... Use to adjust the image when its motion does not run
smoothly. When VIDEO is selected as the source,
select AUTO normally. When COMPUTER is selected
as the source, select OFF normally. Especially when
the motion in the projected image doesn't run
smoothly, select AUTO.
SHUTTER(U) ..... Use to adjust the image when the noise etc. appears on
top part of image.
SHUTTER(L) ...... Use to adjust the image when the noise etc. appears on
bottom part of image.
SHUTTER(LS) .... Use to adjust the image when the noise etc. appears on
left side of image.
SHUTTER(RS) ... Use to adjust the image when the noise etc. appears on
right side of image.
/ / /
C /YP P ) or RGB. This can be
B R B R
/ English / Español / Deutsch / Français
)
opt.
SIGNAL
HORIZ.POSITION
VERT.POSITION
TRACKING
FINE SYNC
COMPUTER
INPUT
R G B
R G B
HOLD
USER
opt.
SIGNAL
SIGNAL - USER
CLAMP
POSITION
CLAMP
CLAMP
CLAMP WIDTH
CLAMP
CLAMP
VERT.SYNC
?
SHUTTER (U)
SHUTTER (L)
SHUTTER (LS)
SHUTTER (RS)
XGA60
0
0
0
0
RGB
ON
OK
XGA60
0
0
AUTO
0
0
0
0
EN – 17