Indicators - Mitsubishi Electric XD211U User Manual

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.
POWER indicator
Normal condition
POWER STATUS
Blinking green Off
Steady green Steady green
Steady amber Steady amber
Abnormal condition
POWER STATUS
Blinking green
Steady green
Steady amber Steady green
Blinking red
Steady green
Steady amber
Off
Blinking green Blinking red
EN-24
CONDITION
Stand-by
The projector is in good condition.
The projector is shutting and the fan motor is cooling the lamp for
shutdown. Do not unplug the power cord or turn the power off
before the POWER LED changes to flashing. The fan motor will
turn off when the lamp has been cooled.
CONDITION
The projector system has some problems with its fan, so the pro-
jector cannot start up.
The lamp has reached its end of life and must be changed soon.
The lamp will continue to operate until it fails. Change the lamp. If
the lamp is off, then the ballast will become malfunction. (during
power on)
Temperature is too high. The lamp will turn off. The fan motor is
cooling the lamp.
The lamp ignition failed.
Temperature is too high or temperature's sensor is error during
stand-by mode.
STATUS indicator
NOTE
POSSIBLE SOLUTION
Contact your dealer.
Replace the lamp and reset the lamp operation time.
Wait until the lamp cools down, and the projector
enters stand-by mode.
Replace the lamp and reset the lamp operation time.
• Wait for 1 hour until the lamp cools down, and
turn the power back on.
• If the temperature is still high after 1 hour, con-
tact your dealer.