NEC N8146-36 User Manual page 23

10.4 Install the exhaust filter B as shown in the figure below.
10.5 Install the stabilizer by sliding it to the direction shown by an arrow.
10.6 While pushing the lower fan unit so that
Note: If the screw does not fit the hole,
10.7 Close the side cover according to Step 8.
※When using the server in vertical installation:
Remove the stabilizers from the front of server, and insert the claws of stabilizer into the slots on the server.
Claws (2 places)
Align these holes with slots on server
chassis to install the filter.
it does not move, secure the exhaust filter B
with a screw as shown in the figure.
confirm that the screw hole on the
lower fan unit aligns with the center
of hole on exhaust air filter B.
Align the stabilizer with slots on
the server.
Secure the exhaust filter B with a
screw removed in Step 10.3.
23
Push the lower fan unit so that
it does not move toward front.