Advertisement
4. Manual operating
The " manual operating button" (see Figure 1, item 4) allows manual control of the
motor unit right after the power is supplied. In order to control the shutter manually, press the
manual control button twice within 1.5 sec. Manual control works in a sequential mode, e.g.
1. First "double-pressing" the button starts the roller shutter armour.
2. Second "double-pressing" the button stops the roller shutter armour.
3. Third "double pressing" the button starts the roller shutter armour in the opposite
direction.
5. Technical parameters
Parameter
Power voltage
Rated current
Working
temperature
Power cable
Weight
6. Signaling description – LEDs
Motor working status (see Fig. 1)
Single LED
flashing
Triple LED
flashing
11.09.19 NC817
Technical parameters
Speed
Current consumed by
the
roller
shutter's
motor is too low
Current consumed by
the
roller
shutter's
motor is too high.
Check calibration of
the motor. Description
of limiters' adjustment
is contained in the
Installation
Manual
of the shutter under
section "A".
ARZ Z-Wave motor
12V DC
1.4 A
23 r.p.m
(-10
o
C) to (65
2 x 0.75 mm
0.850 kg
Network status (see Fig. 1)
The device has not been associated
with any network, i.e. remote
control of the device is not possible.
This LED always comes on after
LED on
connecting the power supply to a
continuously
brand new motor. It is switched off
the moment the device is added to a
network
"INCLUDE" function.
6/8
o
C)
2
with
the
use
of
©2011, FAKRO
Advertisement
