Ccc Declaration; Safety Instructions - Magicard Enduro Duo User Manual

The information contained in this document is subject to change without notice.
Ultra Electronics Limited shall not be liable for errors contained herein or for incidental consequential damages in
connection with the furnishing, performance or use of this material.
This document contains proprietary information belonging to Ultra Electronics Limited and may not be wholly or partially
copied, stored in a data retrieval system,or used for any purpose other than that for which it was supplied, without the
express written authority of Ultra Electronics Limited. All rights are reserved.
®
MAGICARD , UltraCoverplus,, Holokote, Enduro, Ultra Shield is registered as a Trademark with the United States Patent
and Trademark Office, Reg. No. 2,197,276
The HoloKote feature of Magicard® printers is protected by US PATENT No: 5,990,918 and by EUROPEAN PATENT
SPECIFICATION EP 0 817 726 B1.
Microsoft and Windows 2000, XP and Vista are trademarks of Microsoft Corporation.
Copyright © 2008 Ultra Electronics Limited.

CCC Declaration

此为A级产品，在生活环境中，该产品可能会造成无线电干扰。在这种情况下
，可能需要用户对其干扰采取切实可行的措施。
WARNING:
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.

SAFETY INSTRUCTIONS

To prevent electric shock do not remove covers.
Do not attempt to service the printer yourself.
There are no user serviceable parts inside. In the event of malfunction, refer servicing to your nearest MAGICARD
Centre.
Use only a power source within the limits marked on the bottom panel.
Take care not to spill any liquid on the printer.
Ensure that the power supply cord is not longer than 2 metres in length and includes a properly grounded connection.
If using this printer in Germany:
To provide adequate short-circuit protection and over-current protection for this printer, the building installation
must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit
einem 16 A-Überstromschalter abgesichert ist.
When handling the printer avoid touching the thermal printing edge of the thermal print head. Any grease and contamination
will shorten its life.
Before transporting the printer, remove the dye film & card hoppers and pack the printer in its original packaging.
Ultra Electronics Ltd
声 明
Magicard Enduro User Manual
- 3 -
®
Service