Set Pc Hyperterminal Parameters - Maipu MP3900X Series Installation Manual

Power on and Run Router
For details about the inner signal connection of the Console cables, refer to
E1 Console
⚫
⚫

4.1.2 Set PC HyperTerminal Parameters

The following takes running Windows XP HyperTerminal on the PC (or laptop) as an
example to describe the setting of the serial interface parameters of the PC (or laptop).
Step 1:
Enable the PC (or laptop), select Start > All Programs > Accessories >
Communication > HyperTerminal, and click
in Figure 4-5. If it is the first time to set the Hyperterminal, the system displays the
interface of Location Information, as shown in Figure 4-3. Fill in according to the red
indication in the fiugre and click OK.
4-2
Cable.
Figure 4-2 Connect the router and PC via the Console port
When the PC (or laptop) is connected with the router via the configuration cable,
first connect the DB-9 side of the configuration cable to the serial interface of the
PC and then connect the RJ-45 connector of the configuration cable to the Console
port of the router.
When removing the configuration cable that connects the PC (or laptop) with the
router, first remove the RJ-45 connector of the configuration cable, and then
remove the DB-9 side of the configuration cable.
Figure 4-1 Console cable
to set up the new connection as shown
copyright©2020 Maipu, all rights reserved
MP3900X Series Router Installation Manual
Appendix