Chassis Intrusion Switch Connector: Jcase1; Fan Power Connectors: Cfan1/Sfan1 - MSI MS-7095 Instruction Manual

Chassis Intrusion Switch Connector: JCASE1

This connector is connected to 2-pin connector chassis switch. If the Chassis is
GND
CINT RU
open, the switch will be short. The system will record this status. To clear the
warning, you must enter the BIOS setting and clear the status.
GND
CD-In Connector: CD_IN1
The connector is for CD-ROM audio connector.
R L

Fan Power Connectors: CFAN1/SFAN1

SENSOR
The CFAN1 (processor fan) and SFAN1 (system fan) support system cooling
+12V
fan with +12V. They support three-pin head connector. When connecting the
GND
wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be
connected to GND.
MSI Reminds You...
Always consult the vendors for proper CPU cooling fan.
IDE Connectors: IDE1 & IDE2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133
controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133
function. You can connect up to four hard disk drives, CD-ROM, 120MB Floppy
and other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a
Master and a Slave drive. You must configure second hard drive to Slave mode by
setting the jumper accordingly. IDE2 can also connect a Master and a Slave drive.
8