Release the screwdriver.
Device installation
The device is supplied without the bracket and mounting screw. You will have to buy them
separately.
No.
Name
1
Lens
two
Front panel
3
Fixing screw
4
Bracket adjustment screw
Attach mounting bracket⑤to mounting surface⑧.
1) Mark the bracket mounting hole positions on the mounting surface⑧,drill four
holes at the marked positions, insert four expansion bolts⑦into the mounting
holes and tighten them.
2) Align the four screw holes on the bottom of the mounting bracket⑤ using the
expansion bolts, insert four self-tapping screws⑥and then tighten them.
Secure the device on the mounting bracket⑤.
remove the wire
device components
Table 8-3 Device components
31
No.
Name
5
Mounting bracket
6
Tapping screw
7
expansion bolt
8
mounting surface