Lowrance X47 Installation And Operation Instructions Manual page 23

Fish-finding & depth sounding sonars
Table of Contents

Advertisement

Attach the unit to the gimbal bracket using the supplied gimbal knobs
and washers. Slide the rubber washers onto the gimbal knobs then
loosely screw the knobs into their sockets. Slide the unit into the
bracket with the rubber washers to the outside of the bracket arms. Tilt
the unit to the desired viewing angle and tighten the knobs finger tight.
For the X47
These units use a quick release mounting bracket. When you run the
cable through the hole, make sure you allow enough slack for tilting the
unit and attaching the connector. (The snug fit of the push-on
waterproof connector requires some force to attach.)
Align the bracket over the cable hole with the cable slots facing away
from you and fit the cable through one of the slots. Fasten the bracket
to the dash using the three screw holes.
Power/transducer cable
X47 quick release mounting bracket. Slots in the base allow
Attach the unit to the bracket by first connecting the power/transducer
cable. Then, hold the sonar unit vertically and slide it onto the bracket
from above. (The back of the unit should be touching the front of the
bracket as you lower it into position.) As you push down, the unit will
lock into place with a distinct click.
To adjust the viewing angle, pinch the ratchets with one hand, then tilt
the unit with your other hand. Release the ratchets and the unit locks
into the new position. To dismount the unit for storage, press the
ratchets and lift the unit off the bracket.
Ratchet
Screw hole
routing the cable from beneath the mount.
19
Rear
(away from viewer)
Cable slot

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

X47ex

Table of Contents