TUYA ATLO-KN1W- Manual

Wi-fi smart door/window magnetic

Wi-Fi Smart Door/Window Magnetic Manual

Product Review:

Smart door and window sensor is WIFI sensor, it is contact magnetic sensor, it detects actions of (opening/closing), which make

it ideal for security alarm systems as well as automation in combination with smart WIFI switch.

Input Voltage: DC3V LR03

Static Current: ≤45uA

Alarm Current: ≤55mA

Low-Voltage Notification: ≤2.2V

Wi-Fi: 802.11 b/g/n

Magnetic control distance: ≥15mm

Working Temperature: -10℃~+50℃

Working Humidity ≤95%RH



1. Download Tuya Smart APP, or scan the QR

code to download

2. Push the mounting bracket upward and

take out the bracket, then insert two batteries

according to the graphics in the battery pin

After batteries are loaded, the indicator lights

are always on and then off.

3. Register the APP with your cellphone number.

Then click "+" on "My Home" or click on the

blank to "Add Device", select security sensor,

and click door magnetic sensors.

4.With the card pick-up Pin in the accessory package, hold

the rest key for more than 5 seconds, and the indicator

Flashes into the automatic network connection mode, enter

The Wi-Fi password according to the prompt , and click confirm.

Table of Contents

Do you have a question about the ATLO-KN1W-TUYA and is the answer not in the manual?

Page 1 Working Temperature: -10℃~+50℃ Working Humidity ≤95%RH  How to use: 1. Download Tuya Smart APP, or scan the QR code to download 2. Push the mounting bracket upward and take out the bracket, then insert two batteries according to the graphics in the battery pin After batteries are loaded, the indicator lights are always on and then off.
Page 2 5. In the automatic Network connection mode, indicator flashes Flashes quickly,holds the reset key for 5 seconds with the card Pick-up pin, the indicator flashed slowly, and enters the manual Network connection model. APP chooses compatible model. According to the prompt, enter Wi-Fi password and click confirm. Then switch to the Wi-Fi setting interface, connect smartlife_xxx Network and return to APP to continue adding devices.