Safety Instructions; Technical Data - Kayoba 023379 Original Instructions Manual

EN

SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS FOR
BATTERIES
• Only use AAA batteries.
• Do not mix different types of batteries.
• Do not mix old and new batteries.
• Remove the batteries when the product is
not in use.
• Do not attempt to charge non-
rechargeable batteries.
• Insert the batteries with the correct polarity.
• Requires 3 alkaline 1.5 V AAA batteries
(sold separately).
SYMBOLS
Read the instructions.
Not suitable for children under
3 years of age.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Range
Flying time
Size
Weight
DESCRIPTION
PARTS
1. Propeller axle
2. Fuselage
3. LEDs
4. Undercarriage
5. Auxiliary rotor
16
8.5 m
8 min
L 22 x W 4 x H 10 cm
43 g
6. Rotor
7. Tail unit
8. Tail stay
FIG. 1
REMOTE CONTROL
1. Infrared transmitter
2. Frequency band selector
3. Climb lever (increase/reduce flying height)
4. Button for LEDs
5. Power switch
6. Control lever
7. Trimming right/left
8. Status light
FIG. 2
ASSEMBLY
Open the battery compartment and insert
3 AAA batteries with the correct polarity.
Replace the battery cover and tighten the screw.
FIG. 3
USE
CHARGING HELICOPTER BATTERY
1. Check that the helicopter is switched off.
2. The status light on the helicopter circuit
board goes red during charging.
3. Connect the USB charging cable to the
helicopter and to a computer or USB
charger.
4. The status light on the helicopter circuit
board goes off when the battery is fully
charged.
RECOMMENDED CONDITIONS
FOR USE
• The product is intended for flying indoors.
When flying outdoors the daylight can
interfere with the infrared radiation.
• Do not fly near persons or other obstacles