Engine Trim Calibration - Lowrance X510C Operation Instructions Manual

1. After selecting Fuel Used as overlay data, fill up your tank and press
| .
MENU MENU
2. Select
NMEA 2000
3. Highlight
F
press .
ENT
4. Use ↑ ↓ to select the location (Port, Center or Starboard) of the en-
gine interface you want to calibrate and press
5. Highlight
F
sage will appear: Are you sure you wish to Fill Tank?
6. Select and press
Y
ES
appear: Do you wish to re-calibrate the device?
7. Highlight
N
burn at least five gallons of fuel. Be sure you run only ONE engine
— the engine connected to your engine interface.
9. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on the page
you customized. If the amount of fuel you added to the tank and the
fuel used figure are off by more than 3 percent, we recommend the en-
gine interface be calibrated.
NOTE:
You must use the gauge's Fill Tank command when filling your fuel
tank to keep the engine interface updated with correct information
on the amount of fuel in the tank.
To calibrate a Suzuki Engine Interface:
10. If calibration is necessary, press
press .
ENT
11. Highlight
F
12. Select
T
ANK
connected to the selected engine interface. Press
13. Highlight
pear: Are you sure you wish to Fill Tank? Select
14. The following message will appear: Do you wish to re-calibrate the
device? Select
15. Repeat these steps for each engine interface you want to calibrate.

Engine Trim Calibration

Engine Trim is calibrated through the Suzuki Engine Interface Device
Configuration menu.
1. Press
MENU
2. Choose
B
US
face connected to the desired engine and press
and press
M
UEL ANAGEMENT
and press
T
ILL ANK
ENTER
and press
ENT
O
M
UEL ANAGEMENT
and press
L
OCATION
and press
F T
ILL ANK
and press
Y
ES
| , select
MENU
and press
S
ETUP
.
ENT
and press
ENT
. The following confirmation mes-
ENT
. The following confirmation message will
. Take your vessel out on the water and
MENU
and press
ENT
to choose the location of the tank
ENT
. The following message will ap-
ENT
.
ENT
and press
NMEA 2000
. Select the Suzuki Engine Inter-
ENTER
110
. Select
T
ANK
.
ENT
| , select
MENU
.
.
ENT
and press
Y
ES
.
ENT
.
ENT
and
L
OCATION
and
NMEA 2000
.
ENT