3-Point Calibration - Lowrance X510C Operation Instructions Manual

3. Select the EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear. Instructions on Calibration will be listed at the top
of the menu.
5. Highlight
N
6.
Select F L
LUID
7. Make sure the fuel tank is empty, highlight
The following message will appear: Empty Level Calibration Com-
pleted.
Press ENT.
Fill up your tank, highlight
8.
Select
9. F L
ULL
The following message will appear
10.
pleted. Press
ENT
display.
Calibrate is highlighted on the device configuration menu (left). Cali-
bration menu (right) with calibration instructions listed at the top.

3-Point Calibration

3-point calibration is designed for tanks that vary in shape from the top
to the bottom. You can begin calibration at any point in the 3-point
process, but we recommend starting calibration with an empty tank.
In a 3-point calibration, you will set three points, one each for empty,
half and full levels.
1. Press
MENU| MENU
2. Highlight
B
ration menu. A list of network devices will be at the top of the page. 3.
Select the EP-15 Fluid Level and press
C
ALIBRATE
, press
P ENT
UM TS
, press ENT, then select E
EVEL
and press
EVEL
, then press
, use ↓ ↑ to select
and press
S
US ETUP
ENT
and press
ENT
and select
2.
MPTY
and press
F L
LUID EVEL
Highlight
ENT.
Full level Calibration Com-
:
repeatedly to get back to the main
EXIT
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
107
.
. The Device Calibration
Press .
ENT
press
L and
EVEL
and press
C
ALIBRATE
ENT.
and press
C
ALIBRATE
and press
.
ENT.
.
ENT
ENT.
.
ENT