Listen LT-800 Design Manual & Manual page 64

LR-400/500 Operating Instructions
DX/Local
interference in a busy RF environment. This is done by limiting the amount of RF gain in the receiver.
When local mode is selected, the range of the receiver is compromised. Depending on your application
and environment, Local mode may be necessary for better performance. DX mode is default.
DX Mode (default)
DX is normal operation. The local mode feature can be used
when many frequencies are being used.
Local mode
Only strong channels will be automatically tuned in
1
To change to DX/Local mode
1A
While the unit is OFF, press and hold the channel down button and turn the unit on.
1B
The LCD shall indicate the current setting "D" or "L".
1C
Pressing the down button will toggle between Local and DX Mode; "D" or "L".
1D
Pressing seek will enter the setting and return to normal operational mode.
Resetting to defaults
1
Reset to default settings
1A
Press and hold the Up and Down channel buttons while turning the unit on.
1B
After the receiver has been reset
58
DX
Press and hold the Up and Down channel buttons while turning the unit on. This will light
up all segments of the display.
After the receiver has been reset, the display will return with defaults present.
NOTE: The defaults are
• Channel: 01
* Channel lockout: All channels active
Local