Lexmark T650dn User Manual page 110

Menu item
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
NPA Mode
Off
Auto
Network Buffer
Auto
3K to <maximum size allowed>
Description
Sets the printer to automatically switch to PCL emulation when a print job
requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
•
When the Off setting is used, the printer does not examine incoming data.
•
When the Off setting is used, the printer uses PostScript emulation if PS
SmartSwitch is set to On. It uses the default printer language specified in
the Setup menu if PS SmartSwitch is set to Off.
Sets the printer to automatically switch to PS emulation when a print job
requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
•
When the Off setting is used, the printer does not examine incoming data.
•
When the Off setting is used, the printer uses PCL emulation if PCL
SmartSwitch is set to On. It uses the default printer language specified in
the Setup menu if PCL SmartSwitch is set to Off.
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
•
Auto is the factory default setting.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Sets the size of the network input buffer
Notes:
•
Auto is the factory default setting.
•
The value can be changed in 1-K increments.
•
The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is set
to On or Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Understanding printer menus
110