Maintenance; Troubleshooting; Warranty - Intec MagicLift 29023 Manual

GB
WARNING
USE THE HANDLE PROVIDED WITH THIS
PRODUCT OR A FACTORY AUTHORIZED
REPLACEMENT ONLY. USE OF OTHER THAN
THE ABOVE MAY NOT ALLOW PROPER RELEASE
VALVE ACTION. BE SURE ALL TOOLS AND
PERSONNEL ARE CLEAR BEFORE LOWERING
LOAD. DANGEROUS DYNAMIC SHOCK LOADS ARE
CREATED BY RAPIDLY OPENING AND CLOSING
RELEASE VALVE WHILE JACK IS LOADED. THE
RESULTING OVERLOAD
HYDRAULIC SYSTEM FAILURE WHICH CAN
CAUSE PERSONAL INJURY AND/OR PROPERTY
DAMAGE.
When ordering parts be sure to have model
number and serial number.
These jacks do not contain customer serviceable
parts.
Jack will not lift load
Poor lift performance
For a period of one (1) year from date of purchase, Shinn Fu Europe B.V. will repair or replace, at its option, without charge, any of its products
which fails due to a defect in material or workmanship, or which fails to conform to any implied warranty not excluded here by. Performance of
any obligation under this warranty may be obtained by returning the warranted product and sales receipt, freight prepaid, to Shinn Fu Europe B.V.
Roosendaal, the Netherlands or return to your retailer.
Except where such limitations and exclusions are specifically prohibited by applicable law. (1) the CONSUMER'S SOLE AND EXCLUSIVE
REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS AS DESCRIBED ABOVE, and (2) Shinn Fu
Europe B.V. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3)
THE DURATION OF ANY AND ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF ONE (1)
YEAR FROM DATE OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
IMPORTANT: USE ONLY PREMIUM GRADE
HYDRAULIC JACK OIL. NEVER use brake, P/S, trans
fluid, glycerin, motor or turbine oil. Improper fluid can
result in jack failure and the potential for sudden and
unexpected loss of load.
ADDING OIL
1. With saddle fully lowered, set jack in its use position.
MAY CAUSE
2. Fill until oil is ~1/4" from bottom of filler hole, install
CHANGING OIL (REPLACE AT LEAST ONCE A YEAR)
1. With saddle fully lowered, remove air vent valve.
2. Lay the jack on its side and drain the fluid into a
suitable container.
NOTE: DISPOSE OF USED OIL IN ACCORDANCE
3. Fill with premium grade jack oil, such as Mobil DTE
LUBRICATION
A coating of light lubricating oil to pivot points will help
to prevent rust. When not in use, store with ram piston
retracted.

TROUBLESHOOTING

Release valve not closed
Overloaded
Air trapped in system
Low hydraulic fluid

WARRANTY

2

MAINTENANCE

Remove air vent valve.
air vent valve.
WITH LOCAL REGULATIONS.
13 or equivalent. Install air vent valve.
Close release valve
Remedy overload condition
With ram fully retracted and jack in upright
position, remove air vent valve to let
pressurized air to escape. Reinstall air vent
valve.
Fill to recommended level.