Passwords; Power-On Password; Hard-Disk Password; Supervisor Password - Lenovo ThinkPad X200 7458 Hardware Maintenance Manual

Lenovo thinkpad x200 7458: supplementary guide
Hide thumbs Also See for ThinkPad X200 7458:
Table of Contents

Advertisement

8. When the recovery process is complete, the Welcome to Microsoft Windows

Passwords

As many as three passwords may be needed for any ThinkPad computer: the
power-on password (POP), the hard-disk password (HDP), and the supervisor
password (SVP).
If any of these passwords has been set, a prompt for it appears on the screen
whenever the computer is turned on. The computer does not start until the
password is entered.
Exception: If only an SVP is installed, the password prompt does not appear when
the operating system is booted.

Power-on password

A power-on password (POP) protects the system from being powered on by an
unauthorized person. The password must be entered before an operating system
can be booted. For how to remove the POP, see "How to remove the power-on
password" on page 35.

Hard-disk password

There are two hard-disk passwords (HDPs):
v User HDP—for the user
v Master HDP—for the system administrator, who can use it to get access to the
Note: There are two modes for the HDP: User only and Master + User. The
Master + User mode requires two HDPs; the system administrator enters both in
the same operation. The system administrator then provides the user HDP to the
system user.
Attention: If the user HDP has been forgotten, check whether a master HDP has
been set. If it has, it can be used for access to the hard disk drive. If no master
HDP is available, neither Lenovo nor Lenovo authorized servicers provide any
services to reset either the user or the master HDP, or to recover data from the
hard disk drive. The hard disk drive can be replaced for a scheduled fee.
For how to remove the POP, see "How to remove the hard-disk password" on
page 35.

Supervisor password

A supervisor password (SVP) protects the system information stored in the BIOS
Setup Utility. The user must enter the SVP in order to get access to the BIOS Setup
Utility and change the system configuration.
Attention: If the SVP has been forgotten and cannot be made available to the
servicer, there is no service procedure to reset the password. The system board
must be replaced for a scheduled fee.
34
ThinkPad X200 Hardware Maintenance Manual
screen is displayed. Follow the instructions on the screen to complete the
Windows setup.
hard disk even if the user has changed the user HDP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkpad x200

Table of Contents