Troubleshooting; Error Messages - Lenovo ThinkPad T61 7659 User Manual

3. While the message, "To interrupt normal startup, press the blue
4. Select Diagnose hardware. The computer restarts and PC-Doctor starts up.
For more information about PC-Doctor, press F1 to go to the Help or online
manual for the program.

Troubleshooting

If you do not find your problem here, see Access Help. The following section
only describes problems that might prevent you from accessing this help
system.

Error messages

Notes:
1. In the charts, x can be any character.
2. The version of PC-Doctor referred to here is PC-Doctor for Windows.
Message
0176: System
Security - The
System has been
tampered with.
0182: Bad CRC2.
Enter BIOS Setup
and load Setup
defaults.
0185: Bad startup
sequence settings.
Enter BIOS Setup
and load Setup
defaults.
0190: Critical
low-battery error
0191: System
Security - Invalid
remote change
requested.
0199: System
Security - Security
password retry
count exceeded.
ThinkVantage button," is displayed at the lower left of the screen, press
the blue ThinkVantage button to enter the Rescue and Recovery
workspace.
Solution
This message is displayed if you remove the Security Chip and
reinstall it, or install a new one. To clear the error, enter the
BIOS Setup Utility. If this does not solve the problem, have the
computer serviced.
Checksum of the CRC2 setting in the EEPROM is not correct.
Press F1 to go to BIOS Setup Utility. Press F9 and then Enter to
load the default setting. Press F10 and then Enter to restart the
system.
Checksum of the startup sequence setting in the EEPROM is
not correct. Press F1 to go to BIOS Setup Utility. Press F9 and
then Enter to load the default setting. Press F10 and then Enter
to restart the system.
The computer turned off, because the battery is low. Connect
the ac adapter to the computer and charge the battery, or
replace the battery with a fully charged one.
The system configuration change has failed. Confirm the
operation and try again. To clear the error, enter the BIOS
Setup Utility.
This message is displayed if you enter a wrong supervisor
password more than three times. Confirm the supervisor
password and try again. To clear the error, enter the BIOS
Setup Utility.
Solving computer problems
Chapter 3. Solving computer problems
13