Replacing The Heat Sink And Fan Assembly - Lenovo ThinkCentre M75e 4162 User Manual

Lenovo thinkcentre m75e 4162: user guide
Table of Contents

Advertisement

7. Install the new power supply assembly into the chassis so that the screw holes in the new power supply
assembly are aligned with the corresponding holes in the rear of the chassis.
8. Install the four screws to secure the new power supply assembly in place.
Note: Use only screws provided by Lenovo.
9. Connect the new power supply assembly cables to all drives and the system board. See "Locating
parts on the system board" on page 9.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 37.

Replacing the heat sink and fan assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink and fan assembly.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three
to five minutes to let the computer cool before removing the computer cover.
To replace the heat sink and fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 14.
3. Lay the computer on its side for easier access to the system board.
4. Locate the heat sink and fan assembly. See "Locating components" on page 9.
5. Disconnect any cables that might prevent your access to the heat sink and fan assembly.
6. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 9.
7. Pivot the handle
1
the plastic retention bracket.
24
ThinkCentre User Guide
to release the heat sink and fan assembly clamp and then disengage the clamp from

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents