Replacing The Hard Disk Drive - Lenovo ThinkCentre A62 3656 User Manual

6. Align the drive bay assembly with the two slots and rails on the sides of the
Figure 20. Installing the diskette drive
7. Connect the diskette drive cable to the appropriate connector on the system
8. Connect the flat cable to the new drive.

Replacing the hard disk drive

This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive:
1. Remove the computer cover. See "Removing the computer cover" on page 14.
2. Remove the front bezel and drive bay assembly. See "Accessing the system
26
User Guide
chassis, and install the diskette drive into the bay from the front until it snaps
into position.
board. See "Locating parts on the system board" on page 11.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Completing the parts replacement" on
page 37.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Important
When you receive a new hard disk drive, you also receive a set of Product
Recovery discs. The set of Product Recovery discs enables you to restore the
contents of the hard disk drive to the factory-installed state. For more
information on recovering factory-installed software, refer to Chapter 3,
"Recovery information," on page 43.
board components and drives" on page 15.