Verify Anti-Tip Bracket Is Installed And Engaged - KitchenAid KSEG950ESS Manual

5. Secure the blower motor strain relief, near the quick
connection end, to the blower electrical terminal cover with the
two provided screws.
6. Locate the two-pin connector on the blower motor wire
harness and connect it to the two-pin capacitor connector.
7. Locate the 4-pin connector on the blower motor wire and plug
it into the terminal connection point directly behind the
capacitor storage tray.
NOTE: The terminal release (clip point) will be facing toward
the front of the range.
8. Install blower electrical terminal cover.
NOTE: When replacing cover, insert the terminal cover tabs in
the corresponding slots in the range, and push the terminal
cover rearward to engage.
9. Install terminal cover screw.
10. Replace the access panel by aligning the studs with the
keyhole slots on the range. Press the access panel forward
into the slots and push downward to engage the studs.
11. Reconnect power.
Verify Anti-Tip Bracket Is Installed
and Engaged
On Ranges Equipped with a Premium Storage Drawer:
1. Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket.
2. Remove the premium storage drawer. See the
"Remove/ Replace Drawer" section.
3. Use a flashlight to look underneath the bottom of the range.
4. Visually check that the rear range foot is inserted into the slot
of the anti-tip bracket.
2
2
25