Download Print this page

Iceking ICE-RZ110W.E Installation And Operating Instructions Manual page 7

48cm under counter freezer

Advertisement

Section 2
Please, read this booklet thoroughly before installing and switching on the
appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
If this appliance is to replace an old refrigerator with a lock, as a safety
measure, break or remove the lock and/or door before disposal.
Your old appliances contain insulation gases and refrigerant that must be
disposed of correctly. Please ensure that the refrigerant circuit is not
damaged before the appliance is taken away for correct disposal in line
with current legislation. If there is any doubt, contact your Local Authority
for instructions.
This appliance may contain the refrigerant isobutene (R600a). This is a
natural gas with a high level of environmental compatibility; however,
caution is required as isobutene is a flammable gas. It is essential to
ensure that refrigerant tubes are not damaged during transportation and
the installation of the appliance. If the refrigerant circuit is damaged, avoid
naked flames or sources of ignition and ventilate the room in which the
appliance is situated.
Do not damage the refrigerant circuit.
Do not allow children to play with plastic bags – tear the bag(s)
immediately and ensure that they are placed in a dustbin out of reach.
This appliance shall not be used by children aged 8 years and below,
unless they have been given instruction on how to use of the appliance in
a safe way. Children shall not play with the appliance.
If using an adaptor, this must be used in accordance with the
manufacturer's instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.
Do not twist or bend the cables and keep them away from hot surfaces.
Do not plug in or unplug this appliance with wet hands.
Following installation make sure that the power cable is not trapped
underneath the appliance.
If the power supply cord is damaged, it must be replaced by the
manufacturer, it's service agent or similarly qualified persons to avoid a
hazard.
7

Advertisement

loading