Detailed Set-Up Guide; Battery Installation - La Crosse Technology WT-5721 Instruction Manual

DETAILED SET-UP GUIDE

II.

BATTERY INSTALLATION

A. REMOTE TEMPERATURE TRANSMITTER
1. Remove the battery cover. Observing the correct
polarity, install 2 AAA batteries. The batteries will
fit tightly (to avoid start-up problems make sure
that they do not spring free during installation).
2. Replace the battery cover.
B. PROJECTION ALARM
1. Remove the battery cover.
2. Observe the correct polarity, and install 2 AA batteries.
3. In addition or instead of
inserting batteries, the AC
adapter can be used. Simply
plug the adapter into the
receptacle on the underneath of
the alarm clock and then plug
in adapter.
4. Replace the battery cover.
5. The projector will activate and remain on if the alarm clock is plugged in. If
only batteries are used, the projector will only be activated when a button is
pressed. The projection is a red light, not harmful under normal usage,
although care should be taken to not look directly into the light.
Note: After the batteries have been installed a tone will sound, and the LCD
(Liquid Crystal Display) will activate. The indoor temperature and the
remote temperature will be displayed (within three minutes). Also, the time
will appear as "-:--". The WWVB search is automatically initiated, and a
tower icon appears and flashes with the time colon (no tower icon will
appear if the WWVB is too weak to be detected, and the time display will
remain on "-:--"). While the WWVB search is being conducted various
numbers will appear in the time display. After 10 minutes, the Projection
Alarm will either display the WWVB time, or discontinue the search if the
time is not found. If the search is cancelled "-:--" will remain in the time
LCD. The Projection Alarm will conduct a WWVB search every hour until
the first signal is found. Once the WWVB time is found, a search is
automatically conducted nightly at midnight. If the signal is found at
midnight, the tower icon will remain, if not, another search will take place
every hour (until 6:00 am) until the signal is found successfully. If no signal
is found during this period, the tower icon will not appear and the clock will
search again at 12:00 am the next night.
5
Battery
Cover
AC adapter
receptacle