HyperX Cloud Buds TWS CEB004 - Earbuds Quick Start Guide

Overview

1. Touch sensor
2. Microphone
3. Charging contacts
4. Charging pins
5. Charging case status LED
6. USB-C charging port
7. Ear tips

Powering on and off the Earbuds

To power on the earbuds, open the charging case.
The earbuds will play a rising tone and automatically reconnect to the last paired device.

To power off the earbuds, return them to the charging case and close the lid.
The earbuds will play a falling tone and automatically begin charging.

Pairing the Earbuds

1. With the earbuds inserted, open the lid of the charging case.
2. If there are no previous connections, the earbuds will automatically enter pairing mode. Otherwise, press and hold the pairing button on the charging case for 3 seconds.
3. On your device, search for nearby Bluetooth devices and select HyperX Cloud Buds TWS.
   The earbuds will play a quick double beep once the connection is successful.

Wearing the Earbuds

1. Gently insert the earbuds into the ear canals.
   
   
2. Slightly rotate the earbuds until the earbuds fit comfortably in the ear and are stable.
   

Controls

	Tap to play/pause music, answer/end calls
	Double tap to skip to next song
	Triple tap to go to previous song
	Hold for 2 seconds to reject call

Status LED

To check the charging case battery level, open the lid with the earbuds inside.

Charging

Questions or Setup Issues?

Contact the HyperX support team or see the user manual at: hyperxgaming.com/support/headsets

Permanent hearing damage can occur if a headset is used at high volumes for extended periods of time.

Battery/TX Power Info

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the useris encouraged to try correct the interference by one or more of the following measures:

1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

Any special accessories needed for compliance must be specified in the instruction manual.

A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment.

Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

©Copyright 2021 HP Development Company, L.P. All rights reserved. All registered trademarks are property of their respective owners. The information contained herein is subject to change without notice. / Tous droits réservés. Toutes les marques déposées sont la propriété de leurs détenteurs respectifs. Les informations contenues dans le présent document peuvent faire l'objet de modifications sans préavis. / HP Inc. 1501 Page Mill Road, Palo Alto, CA 94304, USA. HP, HQ-TRE, 71025 Boeblingen, Germany. HP Inc UK Ltd, Regulatory Enquiries, Earley West, 300 Thames
Valley Park Drive, Reading, RG6 1PT.