Automatic Programmes - AEG PRO COMBI User Manual

14 www.aeg.com
flashes in the display.
3. Use
or
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes.
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
5. Deactivate the appliance.
7.5 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a
programme) and temperature (refer
to "Setting the oven function" and
"Changing the temperature").
2. Set the DURATION (refer to "Setting
the DURATION").
3. Touch
flashes in the display.
4. Touch
function.
The display shows
indicator. This indicator shows which
clock function is activated.
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
7.6 Setting the MINUTE
MINDER
Use the MINUTE MINDER to set a
countdown (maximum 23 h 59 min). This

8. AUTOMATIC PROGRAMMES

WARNING!
Refer to Safety chapters.
There are 25 automatic programmes.
Use an automatic programme or recipe
or to set the END and
to confirm. First you set the
again and again until
to set the SET+GO
and with an
function has no effect on the operation
of the oven. You can set the MINUTE
MINDER at any time and also when the
appliance is off.
1. Touch
and "00" flash in the display.
symbol
2. Use
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch
starts automatically after five
seconds.
When the set time ends, an acoustic
signal sounds for two minutes and 00:00
and flash in the display.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
7.7 Setting the Time delay
function
The DURATION
used at the same time, if the appliance is
to be switched on and off automatically
later. In this case, first set the DURATION
and then the END
to "Setting the DURATION" and
"Setting the END" ).
When the Time delay
function is activated, the
display shows a static
symbol of the oven function,
dot shows which clock
function is on in the Clock /
residual heat display.
when you do not have the knowledge or
experience on how to prepare a dish.
The display shows the shelf position and
the default cooking times for all
automatic programmes.
.
or to set the MINUTE
or the MINUTE MINDER
and END
function (refer
with a dot and . The
can be