Programming The Remote - LG 30FS4D Owner's Manual

Programming the Remote

The remote control for your HD receiver is a multi-
brand or universal remote control. It can be pro-
grammed to operate most remote-controllable
devices of other manufacturers.
Note that the remote control may not control all
models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate the component without programming,
turn on the component such as a VCR and press
the corresponding mode button (VCR) on the
remote control, while pointing at the compo-
nent. Test the POWER and CH +/- buttons to see
if the component responds properly. If not, the
remote requires programming to operate the
device.
Turn on the component to be programmed, then
2
press the corresponding mode button on the
remote control.
3
Press the POWER and MUTE buttons simultane-
ously, the remote control is ready to be pro-
grammed for the code.
4
There are two ways to find the right code for the
component.
A. If you press the CH +/- buttons repeatedly,
the codes will change one at-a-time. Press the
POWER button after each code change. If the
right code is found, the device will turn off.
B. Enter a code number using the number but-
tons on the remote. Programming code num-
bers for the corresponding component can be
found on the following pages.
Again, if the code is correct, the device will
turn off.
5
Press the EXIT button to store the code.
Test the remote control functions to see if the
6
component responds properly. If not, repeat
from step 2.
VCR CABLE DVD SAT
TV
MODE *
2
TV INPUT TV/VIDEO
COMP2 HDMI
1 2
4
4 5
7 8
0
DASH(-)
MUTE
3
EZ SOUND
VOL
RATIO FREEZE
TIMER
INFO
MENU
PLAY
PAUSE
STOP
REW FF
POWER
3/4
COMP1
FRONT
3
6
9
FLASHBK
FAV
EZ PIC
4
CH
SAP SURROUND
CC
SIGNAL
EXIT
5
RECORD
SKIP
P A G E 4 7