Safety And System Precautions; Definition Of The Safety Symbols; Operational Warnings - Beko CLEARPOINT V Installation And Operation Manual

1.

SAFETY AND SYSTEM PRECAUTIONS

1.1

Definition of the Safety Symbols

Before attempting any
General Warning:
service, please read
Risk of damage or injury
the manual
Warning:
Do not operate if parts
Water cannot be used
are missing or have been
to extinguish fire
Compressed air inlet connection
1 Only experienced and trained personnel familiar with all of the relevant laws, rules and regulations, capable to perform the needed activities and to identify and avoid
possible dangerous situations while handling, installing, using and servicing the machine.
1.2

Operational Warnings

WARNING: VESSELS UNDER PRESSURE
+
In most countries, states, cities and/or local municipalities the installation, operation and
maintenance of devices where pressure vessels are in use are subject to local boiler and pressure
vessel regulations.
+
The end user is responsible for following all of the relevant laws, rules and regulations and ensuring
that only experienced and trained personnel install and/or operate the carbon tower.
+
In most countries, states, cities and/or local municipalities the installation may only be carried out by
a licensed installation company. Inspections must be carried out by a qualified and licensed third-
party firm in accordance with all applicable laws, rules and regulations for the region where the
carbon tower is installed.
+
The pressure vessels used in this device are built according to the American Society of Mechanical
Engineers (ASME) standard Section 8, Division 1.
Compressed Air Warning:
Compressed air is a highly dangerous energy source.
+
Never work on the carbon tower while components are under pressure.
+
Never point the compressed air stream or the condensate drain outlet towards anybody.
The end user is responsible for the installation of the carbon tower as laid out in this manual. If proper
commissioning steps are not followed, the warranty will be void and dangerous situations involving injury or
death and/or damages to the machine could occur.
Any change to the machine or to the standard operating parameters (see page 6), if not previously verified
and authorized by the manufacturer, in addition to creating a potentially dangerous situation, will void the
warranty.
CLEARPOINT® V Series Activated Carbon Tower
Electrical Hazard:
Possibility of
electrocution
Warning:
Warning:
Machine level noise
may exceed 85 dBA
tampered with
Compressed air outlet connection
Warning:
Under pressure
Warning:
Personal
protection
required
(Rev. B)
Warning:
High temperature Non-breathable air
Warning:
Operations that can be
All work to be
performed by qualified
performed by qualified
personnel only
Connection point for condensate drain
Warning:
operators 1
5