Spark Arrestor; Instruction Of Atv's Maintaince - X-PRO Y-6 User Manual

SPARK ARRESTOR

The spark arrestor must be cleaned for every 50 hours of use to ensure the
proper performance. If not cleaned on a regular basis, the carbon build-up of
cinders can begin to block your vehicle's exhaust flow and slow down your
vehicle.
● Turn off the engine and cool off to prevent possible injury from burns.
● Remove the 3 screws from the back of the exhaust assembly.
● Carefully removing the heat resistant gasket from the spark arrestor without
damaging so it can be used again.
● Cleaned the screen with detergent, water or wire brush, then let it dry.
● Remove all of the carbon and cinders still inside the exhaust chamber using
a small towel or small vacuum.
● Make sure the heat-proof gasket seals properly and re-install spark arrestor.

INSTRUCTION OF ATV'S MAINTAINCE

ATV need to be maintained after a period time of using. Because some part of
ATV will be rust, fray, distortion, loosing. And these change will reduce the
safety, economic, flexible of ATV. So to keep it is clear, safety, using longer,
reduce its using charge, we have to do the following ways:
1. Clear all of the part
2. Renew and replace the dirty fuel and the worned parts
3. To inspect every parts, according to the instruction and the technical
information
4. If you find any problem, pls amend them immediately
5. To keep the ATV safe, we suggest you lock it when you don't ride it.
18