Table of Contents
Advertisement
LUBRICATION
LUBRICATION
•
It is extremely important that the following lubrication schedule be followed: Bearings: use a good quality
multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using
grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines
and connections on grease banks for leaks.
•
Oilbath Oil: Use a good high quality universal oil. Use an oil that meets or exceeds hydraulic oil grade. Fill to the top
lower oilbath roller chain. Change yearly or whenever contaminated.
•
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under a
no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize
heat-up during operation.
ITEM
LUBRICATION
INTERVAL
1
8 HOURS
2
8 HOURS
3
8 HOURS
4
ANNUALLY
5
20 HOURS
6
7
50 HOURS
8
6 MONTHS
OPERATION
REPLACEMENT PARTS
1 1 1
3 3
5
6
IF APPLICABLE
CAPACITY
APPROX. 3.5 GALLONS
18 PTS
3 3
3
3
LUBRICATION
OIL TYPE
HIGH QUALITY MULTI PURPOSE GREASE
CHAIN LUBE OIL
GOOD QUALITY HYDRAULIC OIL
MOBILE 629 GEARLUBE
Page # 17
4
4
3 3
LOCATION
FRONT AUGER & REEL BEARINGS
REAR AUGER & REEL BEARINGS
DRIVELINE BEARINGS & UNIVERSAL JOINTS
WHEEL BEARINGS (REPACK ANNUALLY)
DISCHARGE BEARINGS (IF APPLICABLE)
DISCHARGE CHAINS (IF APPLICABLE)
OIL BATH OIL (CHECK LEVEL)
REPLACE ANNUALLY
PLANETARY
READ complete manual CAREFULLY
BEFORE attempting operation.
8
2
7
Advertisement
Table of Contents
