Fixing Installation Plate; Drilling A Hole In The Wall - LG LA091CNP Installation Manual

Installation
Fixing Indoor Unit
1. Attach an Installation guide map on the
desired surface.
INSTALLATION GUIDE MAP
3. Make a hole with a diameter of 6mm and
depth of 30-35mm by piercing a screw
point.
5. Drive the fore plastic anchors into drilled
points.
Plastic anchors
7. Hang the hole of product at the upper
screws, and remove the map. (Falling
attention)
Hanger hole
(Rear side of
the product)
9. Check the fixed product with light power.
Drill a Hole in the Wall
• Drill the piping hole with a ø50mm hole core
drill. Drill the piping hole at either the right or
the left with the hole slightly slanted to the
outdoor side.
16 Room Air Conditioner
I N
S T
A I
I A T
I O
N
G U
I D
E M
A P
I N
S T
A L
L A
T I O
N
G U
I D
E M
A P
I N S
T A L
L A T
I O N
G U I
D E
M A P
2. Look at suited horizon by horizontal
meter on the horizontal setting line, and
fix lightly the map by adhesive tape.
Horizontality
4. Drill the pierted part as a diameter of 50mm
for connecting piping. (In case of piercing
rear surface)
6. First, Drive the two points of the upper
parts by screws. (Leave 10mm for hanging
the product)
I N
S T
8. Drive the lower parts after facing the hole
of product with plastic anchors, and fix
completely the upper screws.
10. In case of nothing wrong, connect the
pipe and the wire. (Refer to installation
manual)
Indoor
I N
S T
A L
L A
T I O
N
G U
I D
E M
A P
A L
L A
T I O
N
G U
Plastic anchors
WALL
Outdoor