Makita GRH08 Instruction Manual page 10

Hammering only
For chipping, scaling or demolition operations, rotate
the action mode changing knob to the
bull point, cold chisel, scaling chisel, etc.
1
Fig.11
► 1. Hammering only
Air duct
CAUTION:
Do not put your finger into the air
duct or do not insert any other object into the air duct.
Otherwise you may get injured or the tool may get damaged.
The air duct is designed to improve the suction perfor-
mance of the dust collection system. For details on how
to install the dust collection system, refer to the instruc-
tions on installing the dust collection system.
1
Fig.12
► 1. Air duct
Hook
Optional accessory
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
The hook is convenient for temporarily hanging the tool.
Before installing the hook, remove the rubber cap from
the screw holes in the mounting bracket. Insert the plate
washers under the bracket, and then tighten the hook
with screws in place.
2
symbol. Use a
Fig.13
► 1. Rubber cap 2. Mounting bracket 3. Plate washers
4. Hook 5. Screws
For use, lift up the arm of the hook until it snaps into the
open position.
When not in use, be sure that the hook is folded back in
the closed position.
1
Fig.14
► 1. Hook 2. Open position 3. Closed position
Fig.15
10 ENGLISH
3 4
2
3
1
5