Regeneration Of The Water Softening System; Rinse Aid System; Rinse Aid; Adding Rinse Aid", Page - Siemens SN63HX62AE Information For Use

Table of Contents

Advertisement

en Rinse aid system
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press
⁠ .
1.
To open the basic settings, press
2.
for 3 seconds.
a The display shows Hxx.
a The display shows
Press
repeatedly until the dis-
3.
play shows H00.
To save the settings, press
4.
for 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional run time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water softening
system after x rinse cycles
Additional run time in minutes
Additional water consumption in
litres
Additional power consumption in
kWh
26
⁠ .
6
7
5
0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
16 - 20°E.

Rinse aid system

Rinse aid system

Rinse aid system

Rinse aid

For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
⁠ .
and lift
2
1

Advertisement

Table of Contents
loading

Table of Contents