Getting Started; Programming Your Coffee Maker - Black & Decker QUICK CAFE CM1240B Use And Care Manual

HOW TO U SE
This product is for household use only.

GETTING STARTED

1. Remove all packing material, any stickers, and the plastic band around the
power plug.
2. Go to www.prodprotect.com/blackanddecker to register your product.
3. Wash removable parts as instructed in CARE AND CLEANING.
4. Clean the inside of your coffeemaker by running two full brewing cycles with
water only, no coffee.
a. Pour fresh, cold water into the water reservoir up to the 10-cup mark,
then place carafe onto the carafe plate.
b. Plug cord into standard electrical outlet.
c. Push the BREW NOW button to immediately brew water through the
coffeemaker without adding coffee.
d. Once the cycle is finished, discard water.
e. Turn off appliance, unplug and allow to cool down for 15 minutes
before repeating.

PROGRAMMING YOUR COFFEE MAKER

Setting the Digital Clock
1. Plug the coffeemaker into a
standard electrical outlet.
2. The numbers and colon ":" on
the digital clock display flashes
"12:00".
3. Press HOUR and MIN buttons until
the correct time appears on the display. The colon ":" will continue to
flash even after the time is set.
4. When the time passes noon, the LED light in the display next to PM
illuminates to let you know you are in PM time. If the PM light is not
illuminated it is AM time.
5. To change the time after it has been set, press either HOUR or MIN
once to enter the time setting mode. Then follow the steps above.
Note: If the appliance is unplugged or power is interrupted even
momentarily, the time may need to be reset.
CM1240B_29052_ES_IB_A.indd 5 CM1240B_29052_ES_IB_A.indd 5
5
4/20/22 4:49 PM 4/20/22 4:49 PM