Programming The Board; Programming The Device; Figure 4.1. Programming Cable Setup; Figure 4.2. Crosslink Programming Setup - Lattice Semiconductor mVision AR0234 User Manual

Lattice mVision AR0234 Sensor Board
User Guide

4. Programming the Board

4.1. Programming the Device

The board is programmed through the Lattice Radiant™ programmer software, which can be started as a standalone
tool or from a Lattice Radiant Project.
To program the Lattice mVision AR0234 Sensor Board using the Lattice EVDK:
1. Connect the LF-EVDK1-EVN board to the DC power adapter (12 V).
2. Connect the board to PC through the USB mini port.
3. Start the Lattice Diamond® Programmer version 3.10 or higher.
4. In the Getting Started dialog box, select the configurations shown in Figure 4.1. Click OK.

Figure 4.1. Programming Cable Setup

5. Select LIFMD for Device Family, LIF-MD6000 for Device, Fast Program for Operation, and
mVision_CSI2_2_parallel_impl1.bit for File Name as shown in Figure 4.5.

Figure 4.2. CrossLink Programming Setup

6. Click the Program button to program and check the status.
© 2021-2022 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal.
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-UG-02124-1.1 11