Oven Light; Appliance Outlets; Oven Door; Storage Drawer - KitchenAid Architect Series II YKERS205 Use And Care Manual

STORAGE DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see "Storage Drawer" section.
Cleaning Method:
Mild detergent

Oven Light

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.

Appliance Outlets

(on some models)
The 120-volt appliance outlets located on the control console
may be used to run portable appliances placed on countertops
beside the range.
The outlets operate independently and are not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop.
Damage to the portable appliance could result if the cooktop is
hot.
Appliance Outlet Circuit Breakers:
The circuit breaker for the appliance outlet on your range is
located on the control console next to the outlet. They are rated
for 10 amps.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Pull forward and down on the hinge latch on each side.
22
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.

Storage Drawer

The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull storage drawer out to the first stop position.
2. Lift up the front of the drawer and pull the drawer out to the
second stop position.
3. Grasp sides and lift drawer top up and out.
To Replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the first
stop position.
3. Lift drawer up again and push until drawer is closed.