KitchenAid Architect Series II KDRS505XSS Installation Instructions Manual page 5

30" (76.2 cm) double oven dual fuel ranges
Hide thumbs Also See for Architect Series II KDRS505XSS:
Table of Contents

Advertisement

Available languages

Available languages

Product Dimensions
B*
C**
A
D
E***
F
35³⁄₄
¹⁄₈
47¹⁄₈
¹⁄₈
A.
" ±
" (90.8 ± 0.3 cm)
C.
" ±
" (119.7 ± 0.3 cm)
cooktop height (minimum)
overall height (minimum) with
with leveling legs screwed all
leveling legs screwed all the
the way in
way in**
28¹⁄₂
¹⁄₄
B. Model/serial/rating plates
D.
" ±
" (72.4 ± 0.6 cm)
(located behind the control
depth with handle
26¹⁄₈
¹⁄₈
panel)*
E.
" ±
" (66.4 ± 0.3 cm)
29¹⁵⁄₁₆
¹⁄₁₆
F.
" ±
" (76.0 ± 0.2 cm)
width
*Model/serial/rating plates may be rotated up from behind the
control panel for viewing from the front of the range.
**Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
Range may be installed with zero clearance to combustible
construction at the rear and on the sides below the cooktop.
D
B
C
A
E
F
J
G
I
K
L
H
L
8½"
(21.6 cm)
14"
***
(35.6 cm)
1½"
2¼" (5.7 cm)
(3.8 cm)
1¼"*
(3.1 cm)
8½" (21.6 cm)**
gas line location
A. 18" (45.7 cm) upper cabinet to countertop
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.
E. 30" (76.2 cm) min. opening width
F. 3" (7.6 cm) min. clearance from both sides of the range to the side
wall or other combustible material.
G. Cabinet door or hinges should not extend into the cutout.
H. 3" (7.6 cm) distance from wall
I. 1¹⁄₂" (3.8 cm) min. from right side cabinet
J. 8" (20.3 cm) width
K. 7" (17.8 cm) min. from floor
L. 2" (5.1 cm) min. from floor
*Drill on centerline 1¼" (3.1 cm) from rear wall for gas supply
line.
**Gas lines must be installed within the shaded area to ensure
proper alignment of this oven with cabinets.
***Recessed electrical plugs must be installed within the shaded
area to ensure proper alignment of this oven with cabinets.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an uncovered wood or metal cabinet.
Page 5

Advertisement

Table of Contents
loading

Table of Contents