Advertisement
Available languages
Available languages
-Preface
This manual describes the items that are important for the user to operate this product safety, correctly, and efficiently.
Before operating this product, please read this manual thoroughly, in particular, "Warning and Cautions" at the beginning
of this manual, with a good understanding of its contents. Please safekeeping this manual for the user refer to it whenever
necessary. If you have any question or find any defect, please contact the nearest dealer or our office mentioned on the
back page.
-Precautions on use
The following warnings and cautions are very important. Be sure to observe them.
- This product can only be used for gasoline, light oil, kerosene and lubricant oil. DO NOT use with the
other solvent. In case of use the other solvent, the product will not under guarantee.
- DO NOT break down this product.
- DO NOT operate this product by near the sparking place. It may cause fire or explosion.
- Make ground connection when working with flammable material or in explosive atmosphere. Rapid
pumping of material can result in static electrical charge. Also, be sure to provide proper ventilation
where a flammable atmosphere may be present.
- Be sure to use antistatic hose when pumping gasoline and other flammable liquids. Be sure the hose is
dedicated hose.
- Wear Anti-static work clothing or shoes instead of silk or synthetic fibers.
- Always wear proper protective equipment (facemask, ear plugs, and safety shoes, etc.) when operating
the pump.
- Some types of solution to be used may contain carcinogens. Read the precautions (SDS, etc.) provided
by the solution manufacturer thoroughly and handle the grease with care.
- Do not discharge material directly onto the ground. Dispose of harmful materials according to the
requirements specified in SDS or local regulations. Also, dispose of pump according to the local
regulations after removing residual material from inside pump. (please contact industrial waste disposal
service.)
- Do not operate handle when foreign substance entering. It may cause damage to pump. In case of
handle gets heavier and
- Discontinue it when you feel a hazard or abnormality during the work.
-Package Contents
Please check the following parts are leak or not before using.
・Pump・・・・・・・・ 1
・Bung adaptor・・・・ 1
・Hose・・・・・・・・ 1
-Assembly Process
1） Cover the discharge hose with sealing tape. Connect the hose to the discharge port.
2） Install the handle to shaft by using set screw.
3） Connect the 3 of suction pipes, and use the bang adapter for temporary fix.
4） After connected the 3) section pipe, cover it with sealing tape. connect to the pump
inlet side.
INSTRUCTION
DRUM DISPENSER
RDS-3 ITEM No.686837
WARNING
generate abnormal noise, please stop operation and inspect the pump.
・Suction pipe・・・・ 3
・Handle・・・・・・ 1
(set screw：1, hex wrench :1)
Hose
Handle
Pump
Suction pipe
Exhaust nozzle
Nozzle holder
Bang adaptor
Advertisement
