Straightening Hair - Silvercrest SHGD 52 A1 Operating Instructions Manual

Straightening hair

1) Prepare the hair as described in "Before straightening".
NOTE
► After the hotplates
will be generated automatically because the steam activation
by each press. Steam is now dispensed from the upper hotplate
want to work with steam from the start, then press the hotplates
together as often as required until steam is dispensed.
2) Start with the lower sections of hair at the back of your head. Work around
the sides to the front:
Take a strand with a width of approximately 2 cm and hold its end tightly
between your index and middle finger of the hand that is not holding the
hair straightener.
► Ensure that the hotplates
Never touch the hotplates
during operation! Risk of burns!
► You need to press the hotplates
the first time steam is dispensed. After this, steam is then dispensed every
time you press the hotplates
together too often without straightening your hair, drops of very hot water
will form. Risk of scalding!
3) Clamp the strand near the root between the hotplates
together.
4) Pull the entire strand through the hotplates
ener quickly downwards from the root to the tips.
5) Proceed in the same way for every strand.
6) Once you have straightened all the strands, switch the appliance off and pull
the power plug from the mains power socket.
7) Allow the appliance to cool down completely.
SHGD 52 A1
WARNING! RISK OF INJURY!
Press the hotplates
have been pushed together about 5 times, steam
do not touch your scalp. Risk of burns!
or the upper part of the hair straightener
together approx. 5 times only before
together. If you press the hotplates
together and push the catch
is engaged
. If you
and press them
by pulling the hair straight-
back in.
37
GB
│
■