Clarity C4230 User Manual page 12

C4230
Charging your battery
Battery must be initially charged for a full 12 hours before first use. Failure to fully
charge the battery may result in the battery developing a memory. If the battery
develops a memory, it will hold less charge with each following charge. Eventually
the battery would have to be replaced. Important: You must charge the handset
12 hours before using in order for the handset to register properly to the base.
*
To install or replace battery
backup batteries
1. Disconnect telephone line cord.
2. Remove batteries from phone.
3. Install four (4) AA Alkaline batteries
with negative (–) end of battery
touching the spring.
Warning: Disconnect telephone line
cord before replacing batteries.
12
Quick Reference Guide
Place handset in base
for battery charge
*
Power Supply
AC adapter and good batteries
AC adapter and no batteries
AC adapter and low batteries
Power failure and good batteries
Power failure and bad batteries
IMPORTANT
Handset battery must charge
for12 hours before using.
Installing the Backup Batteries
If there is a power outage, the C4230
will operate up to four hours with
(4) AA Alkaline (non-rechargeable)
batteries (not included).
Note: Operation time depends on
what features are being used.
STEP 1
After installing the four (4) AA
Alkaline batteries, please refer to the
chart below.
Power LED Status
Steady Green
Steady Red
Blinks Green/Red
Slow flashing Red
Fast flashing Red
STEP 3
–
+
–
+
–
+
STEP 2
–
+
(4) AA Size 1.5V