Kenwood KVT-M707 Instruction Manual page 69

? No sound can be heard, or the volume is low.
✔
Attenuator is turned on.
Turn off Attenuator.
✔
The fader or balance settings are set all the
way to one side.
Reset the fader and/or balance settings.
✔
The input/output wires or wiring harness are
connected incorrectly.
Reconnect the input/output wires or the
wiring harness correctly. See the section on
<INSTALLATION MANUAL>.
The sound quality is poor or distorted.
?
✔
One of the speaker wires is being pinched by a
screw in the car.
Check the speaker wiring.
✔
The speakers are not wired correctly.
Reconnect the speaker wires so that each
output terminal is connected to a different
speaker.
? Radio reception is poor.
✔
The car antenna is not extended.
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
? The memory is erased when the ignition is
turned off.
✔
The battery wire has not been connected to
the proper terminal.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
✔
The ignition and battery wire are incorrectly
connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Does not switch to the rear view camera video
?
display when pressing the [V.SEL] button.
✔
The reverse sensor wire is disconnected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
69
|
English