Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Intertec Data Systems CP MICROTHERM DBNA
Summary of Contents for Intertec Data Systems CP MICROTHERM DBNA
- Page 1 Operating Instructions CP MICROTHERM DBNA HOM146708235Ien-4 • 05/02/2020...
-
Page 2: Table Of Contents
www.intertec.info Table of contents 1 General .................................. 3 2 Use ................................... 3 3 Special conditions for safe use.......................... 3 4 Explanation of symbols for warnings and signal words .................. 3 5 Safety information .............................. 4 6 Installation accessories ............................ 4 7 Technical Data ................................ -
Page 3: General
Operating Instructions CP MICROTHERM DBNA 4. The maximum admissible ambient temperature, the General self-heating rate and, if required, the thermal conduc- These operating instructions describe the safe and tion (medium) shall be considered in determining the proper way to work with the device. The safety informa- operating temperature (max. -
Page 4: Safety Information
Operating Instructions CP MICROTHERM DBNA If one of the components listed here is not included in NOTICE the scope of delivery, then please contact the manufac- turer. NOTE It is essential to pay attention to this safety advice as you Technical Data may otherwise incur material damage. -
Page 5: Installation
Operating Instructions CP MICROTHERM DBNA Temperature class Thermostat Rated output Rated voltage/Operating voltage Illustration 1: Example: CP MICROTHERM DBNA 50 T3 TS10 label Installation NOTICE Carefully remove When removing from the packaging and during trans- port, the connection line must not be stressed or bent. - Page 6 Operating Instructions CP MICROTHERM DBNA In a TT or TN system, a residual current device (RCD) must be used where the measured triggering residual current does not exceed 100 mA. Residual current devices with a measured triggering residual current of 30 mA are preferable.
- Page 7 Operating Instructions CP MICROTHERM DBNA Repairs may only be carried out by the manufacturer in the factory. All components have to be kept clean and free of dust and harmful substances that could lead to excessive temperature rise. In the dust Ex area, the applicable requirements of...
-
Page 8: 15 Certificate Of Conformity
Operating Instructions CP MICROTHERM DBNA • Sort other components according to their material Further information and service properties and dispose of them. If the information contained in this instruction manual should not be sufficient in any way, then INTERTEC...
Need help?
Do you have a question about the CP MICROTHERM DBNA and is the answer not in the manual?
Questions and answers