Audio Preset Recall; Firmware Version Display; Demonstration Mode Setting - Kenwood KDC-MP535U Instruction Manual

Other than Standby mode

Audio Preset Recall

Recalling the sound setup registered by <Audio
Preset Memory> (page 26).
1
Select the source
Press the [SRC] button.
2
Enter Menu mode
Press the [MENU] button.
"MENU" is displayed.
3
Select Audio Preset mode
Push the Control knob towards up or down.
Select the "A-PRESET" display.
4
Enter Audio Preset mode
Press the Control knob for at least 1 second.
5
Select the Audio Preset Recall
Push the Push the Control knob Control knob towards up or down
Select the "RECALL" display.
6
Recall the Audio Preset
Press the Control knob for at least 2 seconds.
The "RECALL" display blinks 1 time.
7
Exit Audio Preset mode
Press the [MENU] button.
⁄
• The User memory of "System Q" in <Audio Control>
(page 8) is changed to the value which was recalled.
• The source tone memory item of <Audio Control> (page
8) is changed to the value which was recalled by the
selected source.
In Standby mode

Firmware version display

Displaying the firmware version with the unit.
1
Select the firmware version display mode
Push the Control knob towards up or down.
Select the "F/W VER" display.
2
Display the firmware version
Push the Control knob towards right or left.
towards up or down. .
In Standby mode

Demonstration mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards up or down.
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).
27
|
English