Advertisement
PREPARING FOR INSTALLATION:
The IR-FMR MKII Receiver cable must reach the proposed location of the IR
connecting block. If not, use CAT- 5 cable to extend the length. Mark the cable with
a wire label, describing where the cable originates from, rather than where it will
terminate. Verify there are 3 inches (76.2 mm) of clearance behind the surface where
you plan to mount the IR-FMR MKII.
INSTALLATION:
1. Determine a mounting location for the IR-FMR MKII.
2. Drill a 1/2" (12.7 mm) hole where the IR-FMR will be mounted.
3. Secure the IR-FMR MKII by tightening the hex nut. DO NOT OVER-TIGHTEN.
4. Run the IR-FMR MKII cable. Label the cable for future reference
5. Strip 1/4" (6.4 mm) of insulation from the end of each CAT-5 wire.
6. Locate the IR connecting block snap and lock connectors and remove them
if they are plugged in
7. Use a small flathead screwdriver or your thumb to raise the locking tabs,
exposing the holes on the connectors
8. Insert each wire into the appropriate hole and snap down the locking tabs
9. Insert the smooth side of the connector plug into the smooth side of the
IR connecting block socket
IR-FMR MKII INSTALLATION DIAGRAM
1
2
3
4
5
POWER
3-30V
12VDC/
AC/DC
OUTPUT
+12V DC
EMITTER OUTPUTS
STATUS
IN
HI
HI
IR-CB2
LOW
LOW
IR CONNECTING BLOCK
IR RECEIVER INPUTS
1
2
Stereo Receiver
Advertisement
